Tascam MF-P01 Bedienungsanleitung

» D00637200A OWNER’S MANUAL CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOTREMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE.REFER SERVI

10 PORTASTUDIO MF-P01 This section describes how to make a 4-track recording using the MF-P01. For this, wewill assume that you are making a recor

PORTASTUDIO MF-P01 11 Recording the first track 1) Press the REC FUNCTION key for track 1 so that the REC indicator flashes. You are now ready to re

12 PORTASTUDIO MF-P01 4) Adjust the recording level for track 2, in the same way as shown above (see"Setting the level"). Use the LEVEL

PORTASTUDIO MF-P01 13 Mixdown 1) Make sure that no REC indicator is lit. To release the "record-ready" track (to make all tracks "

14 PORTASTUDIO MF-P01 MF-P01, and may damage the amplifier. Only useoutputs which are marked LINE OUT, PRE OUT,DIRECT OUT and so on. Avoid using an

PORTASTUDIO MF-P01 15 Tracing faults in a recording setup is often a mixtureof logical deduction and patience. Very often, theproblem is caused by

Headphone output (1/4" stereo phone jack)Output level: 4 mW + 4 mW Output impedance: 30 Ω Frequency response: 50 Hz to 12.5 kHz +/-3 dB Signal

2 PORTASTUDIO MF-P01 Important Safety Precautions IMPORTANT (for U.K. Customers) DO NOT cut off the mains plug from this equipment. If the plug fit

PORTASTUDIO MF-P01 3 CAUTION: … Read all of these Instructions. … Save these Instructions for later use. … Follow all Warnings and Instructions ma

4 PORTASTUDIO MF-P01 The TASCAM MF-P01 PORTASTUDIO allows youto perform multitrack recordings which are notpossible with an ordinary stereo casset

PORTASTUDIO MF-P01 5 Record-protecting cassettes The record-protect tab on a cassette stops yourecording on that side when it is removed. The MF-P

6 PORTASTUDIO MF-P01 What you need to make recordings Apart from the MF-P01 itself, you will need:• Some kind of stereo master recorder (such as a

PORTASTUDIO MF-P01 7 1 DC IN 12 V connector and POWER switch Use this jack to connect the PS-P2 AC adaptor which comes with your MF-P01.When conne

8 PORTASTUDIO MF-P01 5 POWER indicator This indicator is lit when the MF-P01 is connected to the power supply and switched on. 6 Tape counter and

PORTASTUDIO MF-P01 9 To change the "record-ready" track, press down the REC FUNCTION switch for the desired track. The cur-rent "r